Title block in wrong scale after inserting

[Anonymous]

Hi,

After I setup the layout page to the size of 36"x24", I inserted  my title block which is also drawn to 36"x24", I insert it in the scale of 1:1. However, the inserted title block was much smaller than the paper size. That is, it been scaled down. Shouldn't the title block occupy the same size as the paper size specified? why is it scaled down? Thanks for any response.

Tony

[maxim_k · Accepted solution]

Welcome to Autodesk Forums!

Hi Tony,

Please look at this topic:

https://forums.autodesk.com/t5/autocad-forum/blocks-insert-at-wrong-in-scale-in-2014-correct-scale-i...

You need to fine-tune measurement units in source and target drawings.

Maxim

[Anonymous]

Thank you Maxim. I will look into what you've suggested.
Tony

[john.vellek]

Hi @Anonymous,

Did Maxim's post get your titleblock scale issue corrected? I sure hope so. If not, can you attach your drawing and titleblock to a post so I can take a look?  Perhaps the layout has no page setup applied that defines its size.

Please select the Accept as Solution button if my post solves your issue or answers your question.