Terminal Strip Editor losing spare data

[mgaudyK243P]

Good morning,

When I insert a spare accessory (in the terminal strip tab), I highlight the location where I want to place it, I give it a starting number of 1, then do a catalog lookup for my partition plate, then insert below.  I repeat this process for two more end covers in other locations of the terminal block editor (numbering 2, then 3).

Then I tab over to LayoutPreview, I chose Wire Numbers Only, then update (screenshot attached of what it should look like with 1 divider and two different style end caps).  Then insert the terminal block.

I go back into the editor and my spare accessories don't appear (it seems like they are not getting saved).  Any thoughts?

[mgaudyK243P]

I figured it out.  In Symbol Builder I needed to assign it as a Panel Terminal (not a Panel Footprint).

[bbowman8E7LC]

can you elaborate?

[CGBenner]

@bbowman8E7LC 

Hello, this post is 3 years old, can you explain which part of the thread you would like to know more about?