Default Dot Tee Marker

[Anonymous]

Every time i get a new node in my drawing, it gets marked with a angle tee but i want it to be a dot tee. Can i set the Dot Tee Marker as default?

[testsubject · Accepted solution]

There are two places that you need to check:

Project Properties and Drawing Properties.

The information is located on the same tab in each: Styles.

If you look in the lower left hand section you will see a box labeled "Wiring Style." This is where you set the type of "Tee" you want.

This can be done a Project wide or per Drawing basis.