Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
My three phase wire number keeps overwriting itself, when I click on L1 it shows the label and then when i click L2 it then overwrites L1 with L2 and then the same with L3, therefore leaving me with just a L3 tag. Also, the tag location is showing up at the end of the line instead of the location marked in my attachment.
It sounds like your wires are all connected which implies that your motor symbol is not built right. If you move the motor away from the wires does it work?
