How to Give 45° Bevel Cut at the Circumference of a Circular Plate

[prakhar.kanungo]

I have 30 mm circular place in my model to which I have to give a 45° bevel cut at the periphery of the plate. 

I have attached 2 snaps for better understanding. 

[prakhar.kanungo]

I have 30 mm circular place in my model to which I have to give a 45° bevel cut at the periphery of the plate. 

I have attached 2 snaps for better understanding. 

[Rob_Merriman · Accepted solution]

 @prakhar.kanungo 

If you look at this thread the steps are in there from @Sebastian_Eiche and @mick-CNF 

https://forums.autodesk.com/t5/advance-steel-forum/groove-pipe-end/td-p/9316575

You need to model a polygon contour, set the boundaries to a couple of mm then use polar array to achieve what you want

[Rob_Merriman · Accepted solution]

 @prakhar.kanungo 

If you look at this thread the steps are in there from @Sebastian_Eiche and @mick-CNF 

https://forums.autodesk.com/t5/advance-steel-forum/groove-pipe-end/td-p/9316575

You need to model a polygon contour, set the boundaries to a couple of mm then use polar array to achieve what you want

[prakhar.kanungo]

@Rob_Merriman  Thanks a lot!

[prakhar.kanungo]

@Rob_Merriman  Thanks a lot!

[AlekVesko]

That is not solution.

He is asking for plate, not for pipe.

[AlekVesko]

That is not solution.

He is asking for plate, not for pipe.

[mick-CNF]

The solution is about the contour cut and polar array which also works on plates.

[mick-CNF]

The solution is about the contour cut and polar array which also works on plates.

[eugenezamula]

Worked for the circular plate. Thanks.
Make sure that Polygon contour, USC for beams is used

[eugenezamula]

Worked for the circular plate. Thanks.
Make sure that Polygon contour, USC for beams is used