Build Corner does not work

[Anonymous]

Hey,

I wanted to use built corner in 3ds Max 2016 but it didn't work. I'm pretty sure I used it properly, actually I did it just how they explained it on the website:

http://help.autodesk.com/view/3DSMAX/2016/ENU//index.html?guid=GUID-D07B4F5B-33AE-4544-A905-A52A678C...

Why is it not working?

Please help me! Is it a bug?

Thank u in anticipation

[Anonymous · Accepted solution]

---

@Anonymous wrote:

Hey,

I wanted to use built corner in 3ds Max 2016 but it didn't work. I'm pretty sure I used it properly, actually I did it just how they explained it on the website:

http://help.autodesk.com/view/3DSMAX/2016/ENU//index.html?guid=GUID-D07B4F5B-33AE-4544-A905-A52A678C...

Why is it not working?

Please help me! Is it a bug?

Thank u in anticipation

---

It seem only to work with editablePoly as a base object but NOT with the editPoly-modifier.

Could be a limitation or bug, but since 'Build end' works with both editablePoly and editPoly i think it`s a bug.

[Anonymous]

I'm sorry it took me so long to response, but thank u a lot for this answer. Should I report it as a bug, because it is just useful in an none destructive workflow, because 90% of all 3d artists I use the modifier way?

[Anonymous]

---

@Anonymous wrote:

I'm sorry it took me so long to response, but thank u a lot for this answer. Should I report it as a bug, because it is just useful in an none destructive workflow, because 90% of all 3d artists I use the modifier way?

---

Yes, if you wan`t this issue fixed you should report it.

[Anonymous]

Still not working in 3ds Max 2019 on edges in Edit Poly mode.

It will work in Edit Poly mode though by selecting the verts.

I run the following macro on the edge selection:

$.modifiers[#Edit_Poly].ConvertSelection #Edge #Vertex
subobjectLevel = 2
$.modifiers[#Edit_Poly].ButtonOp #RemoveEdge
macros.run "PolyTools" "BuildLoopCorner"

Essentially, it converts the edge selection to verts, deletes the edges and runs the loop corner command.

[Kranos_Orphydian]

2020.2 and its still doesnt work on Edit poly modifier. Man they are bare to useless this way. None from Autodesk havent give any reply to this.