Revit sections....
I am used to Autocad Architecture where I typically detail out my sections. I show the top and bottom plates, gypsum wallboard, beam sections, ACT tile layout, etc...
In Revit, the annotation scale seems to be too small to make it look good. I just get thick lines at 1/4" scale - looks sloppy. I have detail set to fine, but it does not seem to do anything until I set the scale to 1-1/2"=1'-0" or greater.
Just curious how everyone else does it. Are your sections just basic linework and you dont add components until you get into wall sections or details.
I have watched tons of videos, and read the tutorials but I have not yet seen anyone actually take a section from start to finish on the sheet. Everyone just shows how you put the section mark down and it atuomatically creates a section view.... Thats great but there is a lot more to do in my mind, I think I know how to add the callouts and annotation but it does not seem very good if I am not pointing at the insulation or pointing to the beam, etc...
I hope this makes sense - any help would be appreciated!
Steve Miles