Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
I have a little problem dispalying a custom Glass Block window family. It won't display when in plan view as it apparently doesn't get cut by the project cut plane. This is even when the center height of the window is exactly at cut plane height. All that shows is a blank area in the wall the size of the window when it should show the joints between glass blocks.
Any ideas, tips, hints are more than welcome.
Many thanks !
Leave the cut plane alone and use Plan Regions to show items that are at a
different cut plane.
wrote in message news:5634170@discussion.autodesk.com...
Hi.
I have a little problem dispalying a custom Glass Block window family. It
won't display when in plan view as it apparently doesn't get cut by the
project cut plane. This is even when the center height of the window is
exactly at cut plane height. All that shows is a blank area in the wall the
size of the window when it should show the joints between glass blocks.
Any ideas, tips, hints are more than welcome.
Many thanks !
Thanx. I should have mentioned that that's been tried. It's not a cut plane problem, or a plan regions problem. It just doesn't recognize this window as a cuttable object. How does one change that ?
Open the familiy and make sure the geometery or symbol lines are set to display in plan view. they may be turned off or may be turnned off at diff. detail levels(coarse,med fine.)
Or maybe I just realized that I hadn't defined the subcategory types in the object "Identity Data" so the machine can't tell a mullion from a hole in the ground. Fixed that, it works, I'm going to go crawl in teh hole now.
