The drawing was ok until I replaced the part with a new similar part.
In the IPN I can see that the part is "tweak" but without any trials.
In the browser (history tree) the part has noe tweak.
It seems that the part have no tweak, but the pictures show something else.
I then use tweak on the part and place it in the right position.
I then updatethe drawing and save it.
When I look at the IDW drawing, the part is not there.
When I make a new IDW it´s still not there.
Ulf
"KJohnson" skrev i melding
news:AC6FF39A25B0506BEDE3CCBB2C7E67CF@in.WebX.maYIadrTaRb...
> Did you use replace on similar parts? Were parts made using save as then
> put into the assembly? IPN's and IDW's have a hard time sometimes picking
> between very similar parts. Can you describe what parts aren't showing up
> and how they were made and put in the assembly.
>
> Do new IPN and IDW show the parts?
>
> Kathy Johnson
>
> "Ulf Kolstad" wrote in message
> news:BD71D466F4506ABA823CFFFDFA19B288@in.WebX.maYIadrTaRb...
> > What am I doing wrong. I have done a part invisibel in a *.ipn
> > When I use this *.ipn drawing in the *.idw drawing the part is still
> there.
> >
> > I have also problems with parts who is visible in a *.ipn but is
> > invisible in *.idw.
> >
> > What´s going wrong.
> >
> >
> > Ulf
> >
> >
>
>