I have had much better luck with R7 than I ever did with R6. I must admit
that I seldom use DA though. I would never go back to R6 and wait for a
service pack. Did you get any errors during your installation of 7? I keep
thinking that your installation may be the problem unless others have seen
this issue.
Ed R
"Adam Warble"
wrote in message
news:69F77767BBCEF3DD655E243D6960AE54@in.WebX.maYIadrTaRb...
> Installed 6 and 7 so I could use 6 as a back up. When I right click on a
> drawing and use design assistance to make a copy of an assembly and
drawing,
> Dr. Watson come and says hi when I save. Everything was fine until I
started
> using 7. This even happened when I just had 7 installed. Sometimes it
> crashes when I exit out of a drawing. Guess I'll uninstall 7 and go back
to
> 6. Wait for service pack for 7.
>
> Anyone else seeing this????
>
> Adam
>
>