Robot Structural Analysis Forum
Welcome to Autodesk’s Robot Structural Analysis Forums. Share your knowledge, ask questions, and explore popular Robot Structural Analysis topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Error message (API)

10 REPLIES 10
Reply
Message 1 of 11
HoshangMustafa
1887 Views, 10 Replies

Error message (API)

Hi

 

Please find the attached file. What is the eroor and how it is solved? I tried The Edit-Correct command, but it didn't solve the error.

 

http://we.tl/mWtimotwdF

10 REPLIES 10
Message 2 of 11

Diaphragms can be assigned to flat horizontal panels. None of 1264to1266 panels is horizontal


Rafal Gaweda
Message 3 of 11

horpan.jpg



Rafal Gaweda
Message 4 of 11

Hi

 

Thanx Rafal. How can I get this table? It looks ok in the polyline contour dialog. I appreciate if you could help this.

Message 5 of 11

Message 6 of 11

Hi Rafal

 

Thanx. I appreciate your solutions. Please find the attached files. I changed the walls to panels to reduce calculations and used RoundUpDown_2.exe and ran the calculations but there is still the error. Is there a way to split the walls into two parts according to your suggestions?

 

http://we.tl/mWtimotwdF

Message 7 of 11

Round Up or Down will not help you because some coordinates of the same panel points are above 1.45 , some below. Use ordinary "round" - addin (attached) This will correct (set correct tolerance before rounding)  1264 1265  but  1266  is not horizontal so it must be calcaulated with Shell calculation model.

BTW why not to use Shell for all of them?

 



Rafal Gaweda
Message 8 of 11

Hi Rafal

 

Please find the attached file. Is it ok?

1- soil pressure

2- water pressure

3- modelling of walss, floors, foundations

every thing.

 

http://we.tl/8SNq2nSEMA

Message 9 of 11

Hi

 

Please find the attached file. Is it ok?

1- soil pressure

2- water pressure

3- modelling of walss, floors, foundations

every thing.

 

If the soil had a swelling pressure of about 35kn/m2, how this can be applied?

http://we.tl/8SNq2nSEMA

Message 10 of 11
Message 11 of 11

If the soil had a swelling pressure of about 35kn/m2, how this can be applied?

 

I do not undestand.
New case? Add this load to walls?


Rafal Gaweda

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report