Community
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Moldflow Ideas
Share ideas for future product features directly with the Moldflow team and collaborate on existing suggestions with your peers.
Submit Idea
Back to Moldflow Insight Category
Submitted by Anonymous on ‎07-21-2017 06:24 AM Submitted on ‎07-21-2017 06:24 AM Status: Gathering Support

Draft Recommendation-Plot

How much Draft is needed to not get scratch marks? Is it 3, 5 or 7 degrees ?? Of course, they depend on how surface is etched, you have VDI 30 or finer, but how should you simulate it?     Erik Andreen Mold Flow specialist Dept: Exterior Phone: +46 702 27 89 20 E-mail: erik.andreen@cevt.se China Euro Vehicle Technology AB Theres Svenssons Gata 7 SE-417 55 Göteborg Sweden www.cevt.se   Show More
Report
1 Comment (1 New)
POST A COMMENT
Categories

Autodesk Design & Make Report

Report a website issue