preset scale zoom in Model mode

Community

Forums

This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service. Translate

Status:

a zoom preset in the Model mode would be useful. set up for a particular monitor could be done by user input after measuring a calibration target (line). I work with parts that are smaller than my monitor, and find it useful to sometimes hold them up to the monitor to compare changes, etc. It would als be handy to provide powers of zoom other than 1... x10, x2, x .5, x .1 for example.

Forums Links

All Forums
Getting started
Contact Support & Downloads
Autodesk Education Support
Trial Support
Autodesk University Home

Can't find what you're looking for? Ask the community or share your knowledge.

Submit Idea