Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Submitted byAnonymouson07-13-201912:51 AM
Status:
Gathering Support
Alingning centerpoints of Lines in F360
When in sketch mode I often want the centerpoint of lines to be coincident with the sketch origin to draw symmetric features. Therefore I draw the line of center and use the "coincident" constraint. Using Inventor, I can directly hover over the line and click the centerpoint to contrain it. In F360 I need to set a midpoint first in order to then constrain it to the origin. Doing this quite often it would save me quite a bit of time during construction.
For the example you show you could just use the midpoint constraint to do it in one hit. Or if you want to use coincident then pick the origin first then press shift and select the midpoint of the line. With Fusion pressing shift enables midpoint selection for constraints and dimensions.
