Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Is it possible to create a (somewhat) intelligent floor plan spot elevation tag with two units of measurement? Manually enter in the height of the floor level in imperial feet (ft.) & inches (in.) & have an automatic conversion to metric meters (m.) in brackets beside or below it?
This would ideally be a block with I am assuming a field with a formula?
Set up carefully enough, Ordinate Dimensions with Alternate Units will do exactly that.
--
Kent Cooper
spinalfarm wrote...
Board,
Re: AutoCAD 2009
Is it possible to create a (somewhat) intelligent floor plan spot elevation tag with two units of
measurement? Manually enter in the height of the floor level in imperial feet (ft.) & inches (in.)
& have an automatic conversion to metric meters (m.) in brackets beside or below it?
This would ideally be a block with I am assuming a field with a formula?
