insert layers into a table with a block or line

[Baker_ADG]

several years ago, I had a lisp routine that would extract the layers in the current drawing, insert the layers and a few settings in a default table, but also add a line to the last column. 

I was not good at backing up all my lisps.. and i lost this one.. 

Does anyone have that routine? it produced the results in the attached drawing. 

thank you.. 

and yes i searched.. 😉

[Baker_ADG · Accepted solution]

never mind... I found it.. lol. 

and attached for the hassle.. 

[Lineabove]

This looks like an interesting lisp.

Would you mind uploading the block that goes with it so I may try it out ?

[Baker_ADG]

the block is called "1inch" 

[hmsilva]

---

@Anonymous wrote:

This looks like an interesting lisp.

Would you mind uploading the block that goes with it so I may try it out ?

---

Hi Lineabove,

the block, is just an horizontal line with 1inch...

Here it is the original thread with pBe's Laytable

EDIT:too slow...and Jon's 1inch.dwg, it's better than a line!

Henrique

[Lineabove]

Thank you.

[Lineabove]

Thank you Henrique.

[hmsilva]

---

@Anonymous wrote:

Thank you Henrique.

---

You're welcome, Lineabove.

Henrique

[Baker_ADG]

pfftt.. egg on my face.. i was the one that originally requested that lisp on CadTutor. .lol.

[hmsilva]

---

@Anonymous wrote:
pfftt.. egg on my face.. i was the one that originally requested that lisp on CadTutor. .lol.

---

Yes you were ...

Henrique

[Baker_ADG]

i forgot my password and can't seem to be able to recover it... grrrr...