Inventor Vault Add-in Causes Slow Frame Generator Performance

Payne_S
Enthusiast
Enthusiast

Inventor Vault Add-in Causes Slow Frame Generator Performance

Payne_S
Enthusiast
Enthusiast

With the Vault ad-in enabled for Inventor, frame generator is extremely slow. When editing the 3D sketch to move a frame member, it seems that the entire frame has to be checked/verified/stamped approved etc. from the Vault. Simply moving a piece of angle can take over a minute. I know it is the add-in because when it is disabled there is no delay and everything is almost instant. It's like the ad-in has to check the status of every frame member when a change is made. We have tried checking out every frame member to see if it helps, nope. Needless to say, this slows the project down tremendously. Has anyone heard of this and found a solution other than disabling the Vault ad-in?

0 Likes
Reply
209 Views
2 Replies
Replies (2)

R_HendersonHHYKK
Contributor
Contributor

I'm having a similar issue with the Shaft Design Accelerator. It is taking ages to perform tasks in the generator. At least over 5 minutes to even load the starting menu and sometimes over 10 minutes to try to change an option in the generator.

 

I've tried unloading the Inventor Vault add-in but this doesn't seem to have fixed it. This was not an issue before my company updated our firewall so I'm going to look into that. Did you find a solution to your problem?

0 Likes

Payne_S
Enthusiast
Enthusiast
Disabling the ad-in is the only thing we have goin need to help
0 Likes