Simulation Mechanical Forums (Read-Only)
Welcome to Autodesk’s Simulation Mechanical Forums. Share your knowledge, ask questions, and explore popular Simulation Mechanical topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Reply
Message 1 of 5
Tracker2012
737 Views, 4 Replies

Track meshing

Tracker2012
Participant
Participant

I am trying to optimize a sprocket drive but need help simulating the rubber belts holding the drive section together.

Any ideas?

 

Have access to Several autodesk products. I was able to get a short simulation in Inventor but i need a more accurate one.

 

I have attached a pdf file showing the basic idea.

Reply
Reply
0 Likes

Track meshing

I am trying to optimize a sprocket drive but need help simulating the rubber belts holding the drive section together.

Any ideas?

 

Have access to Several autodesk products. I was able to get a short simulation in Inventor but i need a more accurate one.

 

I have attached a pdf file showing the basic idea.

4 REPLIES 4
Message 2 of 5
Tracker2012
in reply to: Tracker2012

Tracker2012
Participant
Participant

i know have a full loop assembly with a drive sprocket and two wheels. The fist run it ran but the belts start to bunch up. So i put a spring between the two wheels and it shows some movement put seems to bind up and stop moving. If any one thanks they can help i can send them the files.

Reply
Reply
0 Likes

i know have a full loop assembly with a drive sprocket and two wheels. The fist run it ran but the belts start to bunch up. So i put a spring between the two wheels and it shows some movement put seems to bind up and stop moving. If any one thanks they can help i can send them the files.

Message 3 of 5
Anonymous
in reply to: Tracker2012

Anonymous
Not applicable

i guess you are in wrong forum....

Reply
Reply
0 Likes

i guess you are in wrong forum....

Message 4 of 5
Tracker2012
in reply to: Anonymous

Tracker2012
Participant
Participant

I am wondering if i could or should try this in Autodesk algor Simulation?

Reply
Reply
0 Likes

I am wondering if i could or should try this in Autodesk algor Simulation?

Message 5 of 5
Anonymous
in reply to: Tracker2012

Anonymous
Not applicable

then  rubber belts  and motion goes non linear....which needs some expert advice...Smiley Tongue

Reply
Reply
0 Likes

then  rubber belts  and motion goes non linear....which needs some expert advice...Smiley Tongue

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report