Utilization

[Anonymous]

I designed simple beam. Where can I find the utilization of the construction? No matter what I chose in 'Maps on bars' -> 'Design it is always it always is equal '0'. Displacements and internal forces are ok.

[EduardoMeruvia]

Hi @Anonymous , 

You need to set up your beam/column/truss elements according to its design parameters first before you can get Utilization results on them. 

You might find the link below very helpful for what  you are looking for. 

https://www.youtube.com/watch?v=GhP9An47EKw&list=PLY-ggSrSwbZqow_60fiqJwS69mg1nQMzk&index=4&t=0s

[Anonymous]

I choose proper cross-section and material, element type is beam. Supperts and forces are also correct. What else can I do? Do I need to pay attention to a part of the video or watch it full?

[Rafacascudo]

send the model . Zip before attaching

[Anonymous]

Beam

[okapawal]

Actually, what do you mean by "utilization"?

Do you want to display a map for Design Ratio on bars?

Run the steel member verification, then the Design Ratio is available.

[Anonymous]

I wanted to check carrying capacity in %. For example, if it's 70% I know I can pick a smaller cross-section. A few years ago I made 3D truss and you could find this option easily, with colorful bars etc. I saw what part of construction could be reduced and where the bars need to be more massive.

In polish 'wytezenie konstrukcji'.

[Rafacascudo]

as @okapawal said earlier