slenderness ratio display issue in utility ratio table

[Anonymous]

Hi,

We are working with the robot structural analysis and when we interpreting the result with other analysis software,we found that the design utilization ratio for column and beams are found to be lesser on robot analysis.

When we taken the detailed report of that member calc. (ref snap below)we found that the robot software is not displaying the design ratio due to slenderness limit in the utilization ratio table. (refer last snap). 

It will be helpful if you can advise us on how to display the slenderness ratio also in the design table.

 the value of 0.84 is not found in the design ratio table (ref next snap below)

 

[Krzysztof_Wasik]

Hi @Anonymous 

This geometrical limitation is reported as "Instable member", when ratio 1 is exceeded.

Slenderness verification can be switched on/off in Steel design calculation Configuration window.

[Anonymous]

thanks for your reply..will check this option.