slab required reinforcement workflow

[chrismcc]

Hello,

Correct workflow problem.  I carry out slab - required reinforcement - no problem.  Then I am stuck.  Sorry, but I cannot figure out the correct workflow to do slab - provided reinforcement.  I want to do this for all of the same panels such that Robot can then carry out the verification calculations for deflections.

Step-by-step instructions required please!  Unfortunately I have a couple of issues like this elsewhere with Robot, but one at a time.

Any help appreciated.

Regards

Chris

[Rafal.Gaweda · Accepted solution]

You will find videos here:
http://www.robotoffice.com/rsa/

[chrismcc]

Rafal,

Thank you.  Unfortunately these videos relate to a much older version of Robot.  Whilst the principles may be the same, the whole appearance is different and I am spending a long time trying to understand what to do next.  Please update these videos - they are almost of no help.

Thank you

Chrismcc

[chrismcc]

I have calculated reinforcement required for every panel on the floor.  I then select 4 panels that I would like to verify.  When I go to the slab provided reinforcement tab, the diagram only shows two panels...  No idea what is going on.

[Rafal.Gaweda]

File please.
Which panels to check?