Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

Robot Snap problem

abdoJFT6M
Observer

Robot Snap problem

abdoJFT6M
Observer
Observer

Screenshot 2024-07-16 165102.png

I am trying to draw nodes on the grid imported from AutoCAD as shown in the photo but the node always comes off the the point. Any clues?

 

0 Likes
Reply
238 Views
3 Replies
Replies (3)

Stephane.kapetanovic
Mentor
Mentor

hi @abdoJFT6M 

after right-clicking on the view, <snap settings>, uncheck the “Grid” checkbox.

Stephanekapetanovic_0-1721194742426.png

note that you can directly open the dxf/dwg file and transform your lines into bars and their ends into nodes.

Best Regards

 

abdoJFT6M
Observer
Observer
How do I transform the CAD lines dwg to members without drawing the truss ?
0 Likes

Stephane.kapetanovic
Mentor
Mentor

Hi @abdoJFT6M

Just open the (dwg) file. 

Best regards.

https://www.youtube.com/watch?v=-vfm3FIr1kU

0 Likes