RC WALL SHAPE C

RC WALL SHAPE C

Anonymous
Not applicable
301 Views
1 Reply
Message 1 of 2

RC WALL SHAPE C

Anonymous
Not applicable

I would like to analize a RC wall shape C, what is the best way to model it,  like just one panel o 3 panels?, i could notice that when it is just one panel  the mesh is close to a circular way. is it model correct?

 

1.PNG

 

the second question is about the model 2 (model on the right), if i decide model like 3 panels in each floor (9 panels in total),  should i  model it  like 3 core walls(1x, 2x , 3y)? or should i model in one core walll like picture 3?

3.PNG

picture 3  (9 panels in one core wall)

 

4.PNG

 

also i didn´t find a option to get  RC shape C wall  desing, just for rectangular wall.

i would like to desing like  shape C

 

7.PNG

I  would like to know your advice, 

any help?

 

attached model

 

 

0 Likes
302 Views
1 Reply
Reply (1)
Message 2 of 2

Rafacascudo
Mentor
Mentor

what is the best way to model it, like just one panel o 3 panels

3 panels

 

 

should i  model it  like 3 core walls(1x, 2x , 3y)? or should i model in one core walll like picture 3?

1 core wall

 

 

also i didn´t find a option to get RC shape C wall desing, just for rectangular wall.

i would like to desing like shape C

 

Not possible ( but not 100% sure as I am no concrete module expert)

 

 

 

Rafael Medeiros
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.

EESignature

0 Likes