no load has been defined

[valentina.ahrens.p]

Hello to all
I have a problem when designing the foundations of a building. I select the corresponding node and at the moment of verifying the foundation, Robot indicates that there are no loads designated.

[Krzysztof_Wasik]

Hi @valentina.ahrens.p 

Refer to

Which is the recommended workflow for concrete footing verification in Robot Structural Analysis

[valentina.ahrens.p]

I have an error in the model at the moment of verifying the foundations, since in "Load Tables" the load combinations are shown, but when I perform the verification, the foundation is calculated as if it had no load on it.
Foundation Results" shows N= 0 kgf/m and My= 0 kfg*m/m.
This causes the design to deliver a very small foundation.

[Krzysztof_Wasik]

Hi @valentina.ahrens.p 

Share zipped model for verification

[valentina.ahrens.p]

I attach the model.
thank you very much for your time.

[Krzysztof_Wasik]

Hi @valentina.ahrens.p 

Refert o video

[valentina.ahrens.p]

Is it ok for "foundations results" to show N=0 and My=0?

[Krzysztof_Wasik · Accepted solution]

HI @valentina.ahrens.p 

You verify geotechnical conditions using ACI code . For ACI soil capacity is verified for SLS combinations. You have only ULS combinations in your model, so only reinforcement (for combinations with asterix) are verified.

[valentina.ahrens.p]

thank so much you for your help 🙂