Check steel elements - bug?

[andrea_pontiggia]

Hello and Happy New Year to all.

I wanted to report this bug.

The value of the cut written in the calculation is the maximum value.

I set the calculation at characteristic points with max Fz. You have opinions about?

Thank You

[Rafal.Gaweda]

Send us model because I do not understand.
On view you look at component 3 results, in steel design component 1...
On view you look at end results, in steel design - in the middle...

[andrea_pontiggia]

Actually you have understood.

Let me know if Robot verification section with the moment Max (then V min as in the table verification) and simultaneously Robot verification section with V max (then M min) but the table shows only the action of calculating more onerous, in my case M in half of the beam.

In summary in the table verification you can see the actions maximum (Mmax Vmax etc.) independently of a specific point of section?

Thanks

[Rafal.Gaweda · Accepted solution]

Robot presents results for point and case which give the highest ratio