Steel connections orientation

[Anonymous]

Good day everyone

When placing a "non-symmetrical" connection (in my case it's singe tube brace gusset from the connections library), the side, from wich bracing beam is being connected to the gusset,  seems to depend on bracing's orientation and cannot be changed in connection's parameters.

Can something be done about that? I need both bracing elements to be connected from one side.  

Thank you in advance

[islam.m.seif]

Hey Maksovs,
Just noted that there are some views to your post but with no replies, may be it needs further clarification. Why don't you draw a handy sketch for the aspired section?

[johnjmbennett · Accepted solution]

There should be an opinion to change from nearside to the far side , under the tab options,

may be be termed above or below, it should work the same as the advance steel one, to allow you to move the tab relative to gusset plate.

[Anonymous]

Thank you, John