Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Per my attached image - is there a method by which rebar can be placed into a corner ? The illustration shows two rebar sets (red and blue) that were created with three host surfaces (edges highlighted in yellow). To continue the rebar sets into the corner I would need to place them (blue set) between the two cyan faces and (red set) between the two magenta faces. Can this be achieved ?
