Is it possible to create a sweep path as a slanted in a generic model?

[Jusung-Kim]

I simply want to create a rectangular profile and path sketch with slanted lines using the Metric Generic Model.rft file. Is it possible?

Profile : rectangular

Path Sketch : Start Point (0, 0, 0) - End Point (10, 10, 10)

I think this creates a slanted rectangular model.

However, even if I try to raise the end point on the floor plan, in 3D, or in the Left View, the mouse is prohibited. Is this impossible?

I have to use generic model category.

[jay_colcombe · Accepted solution]

This is because the Path is defined to the Reference Plane.  Therefore you need to either set the reference plane to the correct angle or use a predefined path. 

You could easily achieve this by using a predefined Rectangular Profile and drawing the Path at the correct angle.

Utilise a Reference Plane and change the Plane to this then Draw your Path on this plane and then use a Profile (or Sketch as required)

Alternatively, you could use a 3D Shape to define the line for the Path then remove it after? 

[Jusung-Kim]

Hello. jay.

It worked for me. Thx.
This is a simple straight line, but is an arc possible?
It was okay, but it wasn't what I wanted. I want it like a spiral.