Very difficult to cleanly ask this question, please understand we are a little new to Revit. Can a Joist or Truss physical justification point be driven by the structural usage setting? By default, our joists have a justification point of "top center" causing them to model too low compared to joist bearing. We are wanting to see if the physical justification point can be driven by the Structural Usage setting so in essence you place the element and change the Structural Use to Joist and it moves the Justification point to the bottom center. In most cases we use "Beam Systems" naturally we would love to move the entire system as a whole to a justification point of bottom center if possible. Any ideas would be appreciated.
