- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
hello, today for some reason, my duct system are not carrying from my duct to my fittings. This is very strange since ive never seen it happen before. For example I tried to use the "Cap Ends" button on some ducts and instead of inheriting the same system of the duct they are attaching to, they come in as "Undefined" and therefore show up as gray in my attached picture, shown next to a propertly system assigned endcap that might as well have been from yesterday (in pink). I first noticed this problem today when I was copying groups of ductwork around, by the copy in place, then move method. But the entire system was changed to "Undefined" inside the newly copy groups. Which is strange because Ive never seen that before either, and I do it all the time. But I chauked it up to groups just being groups (ie: weird and difficult) but when it started happening to all of my systems, in groups or not I am starting to worry. Does anyone have any ideas what the heck is going on?
Solved! Go to Solution.