That's it. Thank you. I have another question or found a issue. I have ductwork that is going to be abandoned in place. I would like to show that in a different line type. Does anyone have any suggestions on how to do that. I was thinking that the linework tool would be the fastest and easiest way to accomplish that, but there is a problem. If the ductwork is round you can't change it's linetype with the linework tool. I am assuming the reasoning for this is that a round ductwork doesn't have a straight edge in the profile. Any suggestions? Another way I thought of would be phasing and filters, but haven't played around with that yet, so I was wondering if anyone else has a solution.