Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

Load Classifications & Demand Factor aren't showing into Panel Schedule-Electrical-Revit

sksaifali99
Contributor

Load Classifications & Demand Factor aren't showing into Panel Schedule-Electrical-Revit

sksaifali99
Contributor
Contributor

If Load Classifications & Demand Factor aren't showing into Panel Schedule, then what should be the reasons behind it?

I'm putting the Load Classifications & Demand Factor values into the family but whenever I'm extracting the Panel Schedule, it isn't shown over there.

0 Likes
Reply
Accepted solutions (1)
944 Views
2 Replies
Replies (2)

fabiosato
Mentor
Mentor

Hello,

 

You can try the following:

1 - Enter in the schedule template editor

2 - Enter in Set Template Options

3 - Select Loads Summary option

4 - In the Show in panel schedule, check A constant set of load classifications, then check Only loads that are connected to the panel, this sequence will refresh the Load classifications linked to the template

Fábio Sato
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.

EESignature

sujanc
Advocate
Advocate
Accepted solution

Check whether the load is properly connected or not, if not then please connect them in circuit and check.

Please select "Accept solution" if the information was helpful (This allows other users with the same issues to find it higher in search results), or reply back if you need more help!
0 Likes