As the title says, I have imported the gbXML file containing all the results from my Trace calculation into Revit. I am curious though as to why Revit, it would seem, is ignoring latent heat information from the trace calcs when displaying the calculated design loads for each of my spaces.
I have attached a snippet of one of my rooms where I have highlighted in yellow the information that Revit is using for design loads and I have underlined in red the information that I want to use for design loads.
As the title says, I have imported the gbXML file containing all the results from my Trace calculation into Revit. I am curious though as to why Revit, it would seem, is ignoring latent heat information from the trace calcs when displaying the calculated design loads for each of my spaces.
I have attached a snippet of one of my rooms where I have highlighted in yellow the information that Revit is using for design loads and I have underlined in red the information that I want to use for design loads.
Yes, latent heat information is a good idea, post it here please :
https://forums.autodesk.com/t5/forums/postpage/board-id/302/load-autosave/true
Yes, latent heat information is a good idea, post it here please :
https://forums.autodesk.com/t5/forums/postpage/board-id/302/load-autosave/true
Put in answer the weblink of your software' editor please.
Put in answer the weblink of your software' editor please.
Can't find what you're looking for? Ask the community or share your knowledge.