Family with multiple connectors an wiring

[christopher.stenersen]

Hi community!

I have some issues with drawing wires between my familys. (lighnting and lighnting device)

I have a lightning device family (knx-device) that have 1 power connector for 230V supply and 1 controls connector for KNX bus supply. 

I draw wires in 2 different wievs for the 230V and KNX wiring annotation, but the wires keep adding homerun arrows when i am trying to draw the KNX bus. 

I think Revit chooses to connect on the power connector and that is the cause?

The power connector is assigned as primary

I there any way to choose what connector that the wire connects to when drawing wires? or is my approach wrong?

[hmunsell]

there are different types of connectors depending on there use. 

this light fixture has 2 power connectors and a data connector. when the Power option is selected you should get an option to which connector to connect to. 

the connector Defines the System Type it can connect to.

[christopher.stenersen]

Yeah that is not quite my issue. 

The issue appears when I annotate wires. lets say if i connect 30 KNX relay modules on the same KNX line with wiring, and those are spread out on 5 electrical circuits on another view with 230V wiring.

Then Revit puts all the circuit information on the wiring 

in this example you can se that I have 5 circuits on the same wire: 

The family has 2 connectors. Control and power:

My hope is thath i could choose if the wiring that is drawed should connect on the control or the power connector for the family.