120/208V single phase Panel

[michaelrupnarain.ipllc]

I have a 120/208V 1 phase generator that feeds an ATS and then a 120/208V 1phase MLO Standby panel. I can't figure out how to make a panel 208/120V single phase. I have been unsuccessful at changing the voltage distribution by using the edit type after selecting the panel. And I can't seem to change it by selecting the connector element in the edit families.

Also, the default 1 phase panel I found in the families is 120/240v Single phase MCB - not sure if that can be altered to make 120/208 Single phase MLO?

  

[HVAC-Novice · Accepted solution]

208 is 3-phase, isn't it? At minimum it is 2-phase if you connect 2 legs. 

240V is residential single phase. 

Revit can do what you want. Just make sure what you do actually exists in the real World. 

[michaelrupnarain.ipllc]

This looks like it works, thanks.

And yes 208 1PH is line-to-line voltage so both the A & B phases are showing on the panel schedule.