Announcements
Welcome to the Revit Ideas Board! Before posting, please read the helpful tips here. Thank you for your Ideas!
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Void/Hole in stairs and landings

Void/Hole in stairs and landings

Would be nice if a shaft or void could cut through stairs and landings or if you could edit the profile of a landing and draw some inner boundary lines to create a hole.

 

Example is a landing which needs an opening around an existing column.

3 Comments
Keith_Wilkinson
Advisor
Riya.ghoshE9ZJD
Autodesk Support

It is not possible to cut through a system stair landing, even with voids. This is a common requirement & would be good to have this feature in Revit. There are multiple suggested workarounds in the forum post below, but these methods are very time-consuming & working with line weights is not a very convenient option.

Forum: https://forums.autodesk.com/t5/revit-structure-forum/create-opening-in-staircase-landing/m-p/7134462...

wr.marshall
Advisor

If for what ever reason this should be allowed in the run too. Would make easier modeling where you have a central column on a circular staircase cutting the treads.

Can't find what you're looking for? Ask the community or share your knowledge.

Submit Idea  

Autodesk Design & Make Report