- Home
- >
- Architecture, Engineering & Construction
- >
- Revit Products Forums
- >
- Revit Ideas
- >
- Allow entering grid lengths when setting them up
Announcements
Welcome to the Revit Ideas Board! Before posting, please read the helpful tips here. Thank you for your Ideas!
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.
Translate
Options
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report
Allow entering grid lengths when setting them up
Allow entering grid lengths when setting them up
When u model a wall you get to click its starting point then point to a general direction and enter the wall's length and are done.
Entering grids is different: While starting out the same by clicking where to begin your grid, trying to enter its length will end the grid command and leave u with no grid but inside the match properties command.
0
Votes
Forums Links
Can't find what you're looking for? Ask the community or share your knowledge.
Submit Idea
