Site settings

[mairh_tsek]

Hello,

Is it possible the contour lines passe from the points that I have create?

I changes the site settings but I cannot find a solution for this. Also in this dialog box I cannot change the 'stop' and 'incresement' column.

Thank you a lot in advance!

[bimscape]

Can you include some screenshots to help explain?

[Corsten.Au]

Topography automatically  creates Primary and Secondary Contours lines rounding off to

5000mm, 10000mm for Primary

and

1000, 2000, 3000 etc for Secondary..

So if you place a point "2250mm" you may not get the contour line going through that point.. but

closer contour lines which passes through 2500mm..

now if you want to see contours lines going through 250mm increments, then you may change the settings here..

am sure you will find what you are looking for here..

( primary contours are thicker, secondary thinner, and in VG you may switch on both , or just keep primary, or just keep

custom ones which you set it up here..

Cheers