Radial array parameter issue

[taejooY875Z]

Hi all

I am setting a round table with chairs around. and I want to control for a number of chairs. I feel like I am almost there but I have one issue.

I was able to control 3, 4, 5 or more chairs around but I can't make just two facing each other. It keeps put one chair diagonal.

 

 

 

[azad.Nanva · Accepted solution]

Yes,You right.this is issue.

it is fixed in Next Version.

use the my family, i use the Hide and Show for this problem:

[Mike.FORM · Accepted solution]

Radial Arrays have always needed to have a count no less than 3.

When they introduced the fix for letting arrays go down to 1 they didn't address the positioning portion for radial arrays.

They just applied the functionality from linear arrays to radial arrays.

[azad.Nanva · Accepted solution]

This is rare, but you can use the two ,if you use the parameter!!! it is really weird 😁.

but in R25 they try to fix this issue,but that was not so good one.they hide the third element ,but this was weird too.because the two element had not good places.🤣

and In The last version they make it happen!!with some issue

[taejooY875Z]

Thank you for your reply and introduction video. 

Yeah this is what I wanted! But still trying to figure out how you did this. Thank you very much!