Community
Hello,
Please see image: I cannot get a clean trim at the "ribs" line of a barrel vault...
The mass is a sweep of a full arch, bending 90 degrees.
The panel is a simple rectangular pattern: I extruded the reference lines of the rectangular family.
I tried with different offsets of the panel, but it does not matter really: Revit does not trim the edge panels properly, on one side is too short, on the other the panels stick out (intersect each other).
Any idea?
thanks
regards
gio
Sie finden nicht, was Sie suchen? Fragen Sie die Community oder teilen Sie Ihr Wissen mit anderen.