Announcements

Starting in December, we will archive content from the community that is 10 years and older. This FAQ provides more information.

Door opening not cutting trhough wall sweep on joined wall

gabriela.dominguezQN4XU
Participant
Participant

Door opening not cutting trhough wall sweep on joined wall

gabriela.dominguezQN4XU
Participant
Participant

In my project, I have two layers of walls, due to the design. I'm also modelling the baseboards as wall sweeps. When I add a door that is meant to cut through both layers of walls, I use the join tool to join the two walls, and this works so the door penetration cuts through both walls. However, this doesn't extend to my wall sweep baseboard. Is there a way to get the door to cut through all the layers automatically? Or is there a way to manually cut the wall sweep in two segments to generate the opening?

0 Likes
Reply
Accepted solutions (2)
785 Views
4 Replies
Replies (4)

ToanDN
Consultant
Consultant
Accepted solution

Is your wall sweep type set to Cut by Opening?  it works fine here.

 

ToanDN_0-1674862691786.png

 

0 Likes

gabriela.dominguezQN4XU
Participant
Participant

I think it is? These are the type parameters:

gabrieladominguezQN4XU_0-1674866306363.png

 

0 Likes

ToanDN
Consultant
Consultant
Accepted solution

Uncheck Cut by Insert.

0 Likes

gabriela.dominguezQN4XU
Participant
Participant

Oh My god, that worked! I thought it made more sense to keep it checked. Thank you very much!

0 Likes