Revit Architecture Forum
Welcome to Autodesk’s Revit Architecture Forums. Share your knowledge, ask questions, and explore popular Revit Architecture topics.
abbrechen
Suchergebnisse werden angezeigt für 
Anzeigen  nur  | Stattdessen suchen nach 
Meintest du: 

Curtain Wall Gap at Mullion - Not trimming to profile correctly

1 ANTWORT 1
GELÖST
Antworten
Nachricht 1 von 2
MaddMatt
290 Aufrufe, 1 Antwort

Curtain Wall Gap at Mullion - Not trimming to profile correctly

Hello, I had some luck with a previous question so I'm back at it again...

 

I created a very simple mullion profile, approximately 1.5" wide by 2.75" deep.  It was easy enough to load into the project, but there is a gap between the edge of the panels and the mullion.  Per the note on the profile family "Curtain Panels are trimmed to where the profile sketch intersects the Center (Front/Back) Ref Plane", but mine are leaving a gap around the boarder of the curtain panel.  Frustratingly, I cant get the panel to trim at the edge of the profile.  See attached images for reference.

 

Thanks in advance... 

 

Beschriftungen (2)
1 ANTWORT 1
Nachricht 2 von 2
MaddMatt
als Antwort auf: MaddMatt

Problem solved... 

My new profile was not overlapping "Center Front/Back Reference Plane" enough and the curtain panel would only partially intersect the mullion profile.  Lesson learned, center my profile on the reference plane axis and offset as needed in the project.

Sie finden nicht, was Sie suchen? Fragen Sie die Community oder teilen Sie Ihr Wissen mit anderen.

In Foren veröffentlichen  

Autodesk Design & Make Report