ReCap Forum
Welcome to Autodesk’s ReCap Forums. Share your knowledge, ask questions, and explore popular ReCap topics.
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service. To translate this discussion, select the language.

ReCap Forum

Post 1 of 3

Scan to mesh feature returning a .smm file only

109 Views, 2 Replies
08-10-2016 05:15 AM

The scan to mesh feature was running for close to 20hrs on my point cloud. When it finally did finish i got the notification that was mesh was complete. However, when i open the mesh folder in A360, under the project, only an *.smm file is present. No .obj, no .rcm. Also the file is only 456kb which would be rather small for the size of the scan.



Post 2 of 3

Re: Scan to mesh feature returning a .smm file only

08-10-2016 07:11 AM in reply to: Tim.Barnes
Hi Tim,

Sorry for the inconvenience! We can look into the issue and will get back to you.

Could you please send me the name of your scan to mesh job in a private message? We may ask for more details on the project later. Thanks!

Post 3 of 3

Re: Scan to mesh feature returning a .smm file only

04-12-2017 02:02 AM in reply to: Tim.Barnes
The same problem happened to me. The name of my scan to mesh job is New Project 5.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post