Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Does Photo to 3D support a mix of nadir and non-nadir source images?
Does Photo to 3D support a mix of nadir and non-nadir source images?
Before I spend 5 Autobucks on a test... Does Photo to 3D support a mix of nadir and non-nadir source images? I'd like to combine photos from a nadir mapping flight with angled photos from one or more POI flights to improve the detail and accuracy of specific buildings on the site. Ideally I'd like to get both a georeferenced ortho tiff and an rcs point cloud for use in Revit.
If this is supported, what are the best settings? Should nadir optimization be on or off? Any other recommendations?
The nadir optimization should be on only when ALL photos are nadir ones. If you process a mix of nadir and obliques (which is possible), the nadir optimization should be set to off.
Regards.
Dominique Pouliquen, Autodesk, Reality Solutions.
Marketing & Market Dev. Director Reality Solutions Group, IPG, Autodesk
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")