ReCap Forum
Welcome to Autodesk’s ReCap Forums. Share your knowledge, ask questions, and explore popular ReCap topics.
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service. To translate this discussion, select the language.

ReCap Forum

Reply
Highlighted
Post 1 of 4
Accepted Solution

accuracy of recap settings??

101 Views, 3 Replies
01-24-2017 07:50 AM

We typically use Scene and we try to get our scans within 1mm mean difference between points and I am not sure if I am reading recap correctly. When I choose the 3 points on a scan and have it match the other scan we see 3 percentages. Overlap  Balance    Point<6mm  my question is would this <6mm be the same as the mean difference between points in Scene? Our client requires a 1mm" min..

@cc4535

 

To answer your question, "would this <6mm be the same as the mean difference between points in Scene? Our client requires a 1mm" min.". 6mm is a bucket showing the percentage of overlapping points in the scan that fall below the 6mm threshold. Most points will be closer and if you hover the mouse over the result you should see a complete list of the results. 

 

See the following post: 


<6mm accuracy

 

 

 

Post 2 of 4

Re: accuracy of recap settings??

01-25-2017 10:30 AM in reply to: cc4535

@cc4535

 

To answer your question, "would this <6mm be the same as the mean difference between points in Scene? Our client requires a 1mm" min.". 6mm is a bucket showing the percentage of overlapping points in the scan that fall below the 6mm threshold. Most points will be closer and if you hover the mouse over the result you should see a complete list of the results. 

 

See the following post: 


<6mm accuracy

 

 

 



Scott Green
Technical Support Specialist
Customer Service & Support
Autodesk, Inc.

Re: accuracy of recap settings??

01-25-2017 11:35 PM in reply to: cc4535

I suppose the 1mm setting is there when you export as a unified cloud (or when you export unified regions)

and also when you import the cloud.

But the setting when Registering is not about what you ask.

 

Post 4 of 4

Re: accuracy of recap settings??

04-20-2017 07:14 AM in reply to: Patrick_Aps_9121

I would defiantly like to see better accuracy. We have to use scene to get our engineering scans to the accuracy required by our clients. Will Recap be getting more accurate in future versions?

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post