Cutting Curves through Macros

[marcelolink]

This is just an example.... actually I want to know how to cut a curve through Macros.

I look forward to any ideas or suggestions.

Thank You.

[jitendra.chaudhari]

Hi @marcelolink, 

Thanks for contacting Autodesk Community Forum. 

I have tried to create a macro for the above requirement but I am not able to input a point inside the limit wizard in order to cut curve at that point using macro in PowerShape. I have raised a change request for this behavior and I will let you know once I would get feedback from the development in the respective change request. 

Thank you for your time and co-operation,