Community
PowerMill Forum
Welcome to Autodesk’s PowerMill Forums. Share your knowledge, ask questions, and explore popular PowerMill topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

TNCremo message

1 REPLY 1
Reply
Message 1 of 2
nubrandao
132 Views, 1 Reply

TNCremo message

Hi, in our Machines heideiain, we use TNC remo to send programs, recently i discover that i could see the screen off my Machine.

 

And some Machine allow me to send a message to pop up the screen? Ia anyone here using this method?

 

Im a cam operator, and program for lot Machines but they are far from my computer and some Times i need to call the operator to stop the program, or Change the program 

 

When i do a MESSAGE "HELLO" in cmd it pops a MESSAGE hello

 

But other Machines dont allow to do that

 

Is there any setting i need to enable on the Machine?

1 REPLY 1
Message 2 of 2
PCTECNI5
in reply to: nubrandao

Hi, like you, I use TNC Remo on a Heidenhain 640, but to write to the operator I connect to the control from my CAM station with VNC Viewer using the IP address, once connected I open LEAFPAD and write a message to the operator and he writes to me...

I hope I was helpful.

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report