post processor error broken connection

[ahorwood]

i'm suddenly getting an error posting code. error cr0002 unexpected error location object: cldatareader. any ideas what's going on?

Aaron Horwood

Tonnard MFG

[jonathan.artiss]

Hi @ahorwood

Thanks for posting on the Autodesk PowerMill forum!

---

@ahorwood wrote:

i'm suddenly getting an error posting code. error cr0002 unexpected error location object: cldatareader. any ideas what's going on?

Aaron Horwood

Tonnard MFG

---

Was this working correctly before? Windows update?

What version of PowerMill and Post Processor are you using? What type of Post are you using? OPT, PMOPTZ?

Cheers,

[ahorwood]

worked Monday. did recently do windows update. version is 2018 on both.

[jonathan.artiss]

@ahorwood

Go to the ? top right > About > Version number?

What type of post is it? OPT or PMOPTZ?

Cheers,

[ahorwood]

Autodesk PowerMill Standard 2018 Version: 2018.1.4.1212164 Build Date: Sun Dec 03 11:17:44 UTC 2017 Status: Full Release

.pmoptz

[ahorwood]

I've tried multiple .pmotz file, including the generics. also tried using 2017 PM with 2017 post processor. tied opening old file that i knew worked. and creating new files also. 

[jonathan.artiss]

@ahorwood

Is your NC program settings page set up correctly? 

It might be best to upload your project and post to a support case. 

Cheers,

[ahorwood]

I started a support case. wish I had a quick answer so I can get back running again.

[jonathan.artiss]

@ahorwood

Whats the support case number? 

Anyone on an active subscription can call 866-681-4359

Cheers,

[ahorwood]

case number 13700575

[ahorwood · Accepted solution]

problem solved. was a stuck windows update screwing stuff up.