Post processor-Broken connection error

[Anonymous]

Some what of a newbie returning to Powermill after 10 years. Getting a Post processor-Broken connection error and I am not sure what I am missing? Is this a tool path connection or a Post file issue? Any info would be most appreciated. Cheers.

[iamcdn79 · Accepted solution]

There is something missing regarding your workplanes in your 'LOWER RAIL HOLES' toolpath. Is there a workplane that needs to be turned on or off for when it was calculated?

[Anonymous]

Thanks for the assist. It lead me down the right path. However it turns out that the root of the issue is in the post. It doesn't support multi axis canned cycles. Thanks again.