Create one NC program for various individual Toolpaths

[saliljajoo13]

Hi everyone,

I use PowerMill 2023, with the Robot plug in to generate programs. I have generated 4 toolpaths for my component, and I when I write NC code using the software, it writes individual NC programs for each toolpath. 

How do I merge it so that the output is just one program.

[cfastNJWK6]

Is this turned on?

If so, turn it off and give it a try.

[iamcdn79]

You need to create a NC Program and make it active then select the toolpaths you want add and select add to NC Program

[saliljajoo13]

No, its not turned on.

But, I checked the NC code, I think there's a main program that calls in Sub Programs.

[huseyin_sahin]

If you are using the Robot plug in ,then you should  be getting  your nc codes  by using it's postprocessing mechanism.